|
Product Name |
HD580Max |
|
Workstation |
Flight Controller Assembly 2 |
Materials
| Name | Part number | Number | Description |
|
M2.5 × 15 mm + 6 mm Hex Standoff |
126-000412 | 4 |
|
| M2.5 × 6mm Pan-Head Phillips Machine Screw | 126-000202 | 3 |
|
| Power board | 135-000488 | 1 |
|
|
M2.5 × 8mm Pan-Head Phillips Stainless Steel Machine Screw |
126-000334 | 4 |
|
| HD540S Avionics Wi-Fi Antenna | 129-000254 | 1 | Alternative: HD540S_ avionics WiFi antenna 129-000322 |
| K-1668 Kafuter Adhesive | 131-000015 |
|
Yellow gum |
| HC403 Avionics Housing Waterproof Gasket | 201-002509 | 1 |
|
Work Instructions
| Step 1 | Lock 4 M2.5 * 15 + 6 hexagonal copper columns to the main board, torque: 0.4 ± 0.04NM |
| Use tools & fixtures | 1. Electric Torque Screwdriver 2. Torque Calibrator 3. Assembly Fixture |
| Operational special requirements | 1. Installation position without abnormalities 2. Stud without leakage lock 3. Stud lock without abnormalities 4. Torque calibration without abnormalities |
| Step 2 | Confirm that the main board connector pin is not broken or tilted, insert the power board in the matching position, and lock 3 M2.5 * L6 mechanism bolts, torque: 0.4 ± 0.04NM |
| Use tools & fixtures | 1. Electric Screwdriver 2. Torque Calibrator 3. Assembly Fixture |
| Operational special requirements | 1. Pin needle without abnormalities 2. No leakage lock 3. No abnormalities in the lock 4. No abnormalities in torque calibration 5. Lock the completed screw, Check and mark |
| Step 3 | Remove the adhesive of the wifi antenna, stick it tightly to the wifi bracket in the specified direction, then place the bracket on the power board according to the positioning hole position, lock 4 M2.5 * 8 mechanism stainless steel drop-resistant screws, torque: 0.3 ± 0.03NM |
| Use tools & fixtures | 1. Electric Screwdriver 2. Torque Calibrator 3. Assembly Fixture |
| Operational special requirements | 1. Screen without leakage lock 2. Screen lock without abnormality 3. Torque calibration without abnormality 4. Check and mark the completed bolt after locking |
| Step 4 | Insert the wifi antenna into the designated terminal, and insert the wifi antenna into the card slot of the power board, and apply yellow glue to the other connector positions on the board. Install the waterproof silicone ring according to the shape position |
| Use tools & fixtures |
|
| Operational special requirements | 1. Yellow glue without leakage points 2. Yellow glue covers the connector and the base on the board 3. The rubber ring does not float, break, or leak |
| General requirements |
| 1. Operators must wear anti-static wrists and finger covers or gloves |
| 2. The workbench should always be kept clean and tidy |
| 3. If you find three similar abnormalities, please report to the production line administrator immediately |
| 4. Label the defective parts and place them in the designated defective product placement box |