|
Product Name |
C31 Flight Platform |
|
Workstation |
Flight Platform Pre-assembly 2 |
Materials
| Name | Part number | Number | Description |
| M3 * 20_ stainless steel flange inner hexagon machine tooth bolt _ whole circle resistant to falling | 126-000751 | 4 |
|
| HD5180-1 Internal Arm Assembly | 755-000028 | 1 |
|
| HD5180-2 Internal Arm Assembly | 755-000029 | 1 |
|
| HD5180-3 Internal Arm Assembly | 755-000030 | 1 | Image transmission installation |
| HD5150 Joint Lock Assembly _ Black Edition | 201-002856 | 4 |
|
| M4 * 14_ stainless steel flange inner hexagon machine tooth bolt _ whole circle resistant to falling | 126-000749 | 8 |
|
| Picture transmission antenna | 129-000426 | 2 |
|
| HD5150 image transmission hoop | 201-002455 | 2 |
|
| HD5180-4 Internal Arm Assembly | 755-000042 | 1 | Image transmission installation |
Work Instructions
| Step 1 | 1. Each with 2 M4 * 14_ stainless steel flanged hexagon screws from the inside to the outside to lock the 4 joint locking components to the designated position of the 4 internal arm components, torque: 1.5 ± 0.15NM |
| Use tools & fixtures | 1. Electric Batch 2. Torque Calibrator |
| Operational special requirements | 1. No abnormal locking of the screwdriver 2. No leakage locking of the screwdriver 3. No abnormal torque 4. No abnormal installation direction |
| Step 2 | 1. Insert two image transmission antennas into the through holes at the bottom of the No. 3 and No. 4 internal arm assemblies, respectively, and thread the antennas out of the rear end holes |
| Use tools & fixtures |
|
| Operational special requirements | 1. The installation of the image transmission antenna is normal |
| Step 3 | 1. Each with 2 M3 * 20_ stainless steel flange hexagonal machine tooth screws to transfer the picture to the 3 and 4 internal machine arm components, torque: 0.8 ± 0.08NM, the screws are locked from the right to the left |
| Use tools & fixtures | 1. Electric Batch 2. Torque Calibrator |
| Operational special requirements | 1. No abnormal locking of the screwdriver 2. No leakage locking of the screwdriver 3. No abnormal torque 4. No abnormal installation direction |
| Step 4 |
|
| Use tools & fixtures |
|
| Operational special requirements |
|
| General requirements |
| 1. Operators must wear anti-static wrists and finger covers or gloves |
| 2. The workbench should always be kept clean and tidy |
| 3. If you find three similar abnormalities, please report to the production line administrator immediately |
| 4. Label the defective parts and place them in the designated defective product placement box |